Kalmar DRF420-60S5, Maintenance Manual

Page: 75 / 600

UDRF01.04GB
Maintenance manual DRF 400–450
1 Engine – 1.7.2 Coolant filter 17
page –
Coolant filter, changing (Cummins engine)
Filter left side, Cummins engine
1. Shut-off valve, coolant
2. Coolant filter
3. Oil filter
NOTE
Close the shut-off valve before the filter is loosened. Coolant
may run out resulting in environmental damage.
1 Machine in service position, see section B Safety .
2 Close the shut-off valve on the filter holder.
3 Clean the area around the coolant filter.
4 Place a receptacle under the coolant filter.
5 Remove the coolant filter with filter tool.
6 Lubricate the O-ring on the filter cartridge with engine oil.
7 Fit the new filter.
Tighten to contact and then another half to three-quarter turn.
8 Open the shut-off valve on the filter holder.
NOTE
Do not forget to open the valve after changing. Otherwise,
the coolant does not pass through the filter and is not
cleaned.
9 Turn on the main electrical power and start the engine.
10 Check that the coolant filter seals tight.
11 Remove the receptacle. Handle the coolant as environmentally
hazardous waste.
A. Position of coolant reservoir (expansion tank)
B. Filling point
C. Level marking, MIN and MAX
12 Check the coolant level in the expansion tank, top up if needed.
A
004851
B
C
https://www.forkliftpdfmanuals.com/