UX-Z7MDR
(No.22042)1-33
(8) Reattach the UD base while engaging the four pins on both
sides of the UD base to the notches of the loading mecha-
nism base and placing the edge (marked
e’
) of the car-
tridge holder assembly under the hook e of the loading
mechanism base. (Fig.24)
Fig.24
(9) Reattach the slide base
(R)
while fitting the two pins on an-
other side of the UD base to the slots of the slide base
(R)
.
(Fig.25)
Fig.25
ATTENTION:
Fit the part
v
of the slide base
(R)
to the part w on the in-
ward side of the cam gear rib. (Fig.26)
Fig.26
(10) Reattach the slide base
(L)
on the slide base
(R)
while fit-
ting the two pins on another side of the UD base to the slots
of the slide base
(L)
(Fig.26). Make sure the two slots of the
slide base
(L)
are fitted to the two bosses marked
E’
and
tighten the two screws
E
. (Fig.27)
Fig.27
Ref:
To expedite the work, bring up the UD base slightly when
fitting each pin to the appropriate notch.
Loading mechanism base
Pin
Pin
Hook e'
Hook e'
Hook e
E
Slide base (R)
Slide base (L)
Pin
Pin
Part w
Part v
Part w
Part v
Slide base (R)
Cam gear
E
E'
E'
Slide base (L)
Slide base (R)
