UX-Z7MDR
(No.22042)1-23
2.3.5 Reinstalling the Pickup Assembly
(Refer to Figs. 15 and 16.)
Reference:
Refer to the explanation of "Removing the Pickup" on the
preceding page.
(1) Fit the P.S. spring and rack plate to the pickup.
(2) Insert the shaft into the pickup.
(3) Engage the hook
k
of the pickup assembly with the CH.
base assembly first, and set the part
j
of the rack plate in
the opening I next. Then, reinstall the pickup assembly
while shifting it to the T-T side (inward) so that the part
m
of the rack plate is positioned as shown in Fig. 16.
(4) Move the pickup assembly to the center position and fasten
the shaft with the two screws
D
. (Make sure that the part n
of the rack plate is correctly engaged with the middle gear.)
(5) After passing the flexible wire coming from the pickup
through the opening of the CH. base assembly, connect it
to the connector CN601.
Note:
When reinstalling the pickup assembly, remove the sol-
der from the shorting round after connecting the flexible
wire coming from the pick to the connector CN601.
Fig.15
Fig.16
2.3.6 Removing the Feed Motor Assembly
(Refer to Fig. 17.)
• Remove the CL. base assembly and tray.
• Remove the mechanism P.C. board.
Remove the two screws
E
fastening the feed motor assembly
from the top of the mechanism assembly.
Fig.17
Part k
Part j
Pickup
assembly
Part I
CH. base
assembly
Middle gear
Part n
Rack plate
Part m
Feed motor assembly
E
