UX-Z7MDR
(No.22042)1-27
2.4.6 Loading assembly
2.4.6.1
Removing the slide base (L) / (R)
(See Fig.10)
(1) Remove the two screws
E
on the upper side of the loading
assembly.
(2) Remove the slide base
(L)
outward. (Release it from the
joint bosses
E
.)
(3) Remove the slide base
(R)
outward.
Fig.10
2.4.6.2
Removing the loading mechanism assembly
(See Fig.11)
(1) Detach the loading mechanism assembly upward to re-
lease the four pins on both sides from the loading motor,
paying attention to the part e of the loading mechanism
base.
Fig.11
2.4.7 Loading mechanism assembly
2.4.7.1
Removing the loading motor
(See Fig.12 and 13)
(1) Disconnect the harnesses from the wire holder and from
connector CN612 on the cam switch board.
(2) Remove the screw
F
attaching the loading motor and re-
lease the joint f.
(3) Remove the belt from the loading motor assembly.
(4) Remove the two screws
G
attaching the loading motor.
2.4.7.2
Removing the cam gear and the cam switch board
(See Fig.12)
(1) Remove the slit washer attaching the cam gear and pull out
the cam gear.
(2) Disconnect the harness from the wire holder and from con-
nector CN612 on the cam switch board.
(3) Remove the two screws
H
and the clamp. Remove the
cam switch board.
Fig.12
Fig.13
E'
E'
E
E
Slide base (R)
Slide base (L)
Loading mechanism
assembly
Loading mechanism base
Part e
Loading motor assembly
F
H
H
Joint f CN612
Slit washer
Cam gear
Cam switch board
Wire holder
Loading motor
Belt
G