UX-Z7MDR
1-22 (No.22042)
2.3.4 Removing the Pickup(Refer to Figs. 11 to 14.)
• Remove the CL. base assembly and tray.
• Remove the TRAMECHA assembly.
Reference:
The pickup can be removed without removal of the mechanism
P.C. board.
Note:
Before disconnecting the flexible wire coming from the pickup
from the connector, be sure to solder its shorting round.
If the flexible wire is connected without soldering, it may cause
breakdown of the pickup.
(1) Solder the shorting round of the flexible wire connected
with the mechanism P.C. board from the back of the TR-
AMECHA assembly.
(2) Disconnect the flexible wire from the connector CN601 on
the mechanism P.C. board.
(3) Turn the idle gear in the arrow-marked direction from the top
of the TRAMECHA assembly so that the pickup assembly is
shifted to the reverse side of the T-T assembly.
Move the pickup assembly until the part j of the rack plate
in the lower part of the pickup assembly comes out of the
CH. base assembly.
(4) Remove the two screws
D
retaining the shaft of the pickup
assembly. Next, disengage the hook
k
from the CH. base
assembly and then remove the pickup assembly together
with the shaft.
(5) Pull the shaft out of the pickup.
(6) Remove the two screws
E
fastening the rack plate from the
pickup.
(7) Remove the screw
F
retaining the P.S. spring from the
pickup.
Fig.11
Fig.12
Fig.13
Fig.14
Flexible wire
Shorting round
CN601 on
mechanism
P.C. board
Pickup assembly
T-T assembly
CH. base
assembly
Part j of
rack plate
Idle gear
D
D
Pickup assembly
Part k
CH. base
assembly
Shaft
E
Pickup
P.S. spring
F
jPart j
Rack plateE