Juniper NETWORK AND SECURITY MANAGER 2010.3, Administration Manual

Page: 714 / 1016

Table 57: Active VPN Table (continued)
Description Item
Type of tunnel: Site-to-site or dial-up. VPN Type
A unique identifier specified when the policy was configured. Policy Id--In/Out
Tunnel status for the active VPN is UP or Down. Status
Rolling average latency (in milliseconds). Ave Latency
Latency for the last ping response. Last Latency
Percentage of time a tunnel is available over the last 30 samples. Availability
Local gateway ID for the active VPN. Local GW Id
Peer gateway ID for the active VPN. Peer GW Id
Local gateway IP address for the active VPN. Local GW IP
Peer gateway IP address for the active VPN. Peer GW IP
Local IP address for the security device associated to the active VPN. Local Address
Peer IP address for the security device connected to the active VPN. Peer Address
Monitoring capability status for the VPN: ON or OFF. Monitor
IPSec (IP security) protocol for the active VPN; AH (Authentication Header)
or ESP (Encapsulating Security Payload). IPSec
SPI (Security Parameter Index) key into the active VPN. A value that
identifies a security association (SA). SPI In
SPI (Security Parameter Index) key out of the active VPN. A value that
identifies an SA. SPI Out
Algorithm used when a user encrypts communication between the security
device and the server. Listed as either SDI or DES. Encryption
Second algorithm used for user encrypted communication between the
security device and server. Authentication
Type of key associated with the VPN: Auto IKE (Internet Key Exchange) or
manual key. Key
Time listed in seconds before re-keying. Lifetime P1
Time reported in remaining bytes before re-keying. Independent from
Lifetime P1. Lifetime P2
Copyright © 2010, Juniper Networks, Inc. 664
Network and Security Manager Administration Guide