Juniper MX2010, Hardware Manual

Page: 336 / 825

NOTE: After a PSM and a PDM are powered on, it can take up to 60 seconds for status
indicators—such as the output status LEDs on the PSM, and the command output on the
craft interface—to indicate that the PSM and PDM are functioning normally. Ignore error
indicators that appear during the first 60 seconds.
10. Verify that the PWR OK LED on the AC PSM faceplate is lit steadily, indicating that PDM is correctly
installed, functioning properly, and providing power to the AC outputs.
11. On the external management device connected to the Routing Engine, monitor the startup process to
verify that the system has booted properly.
12. Verify that the router powers up and goes through the system initialization process.
RELATED DOCUMENTATION
Initially Configuring the MX2010 Router | 351
Maintaining and Verifying the Status of the MX2010 Router Components | 609
Initially Configuring the MX2020 Router
Maintaining and Verifying the Status of the MX2020 Router Components
MX2000 Three-Phase Delta AC Power Distribution Module Description | 100
MX2000 Three-Phase Wye AC Power Distribution Module Description | 102
Connecting the MX2000 Series Router to a Console or Auxiliary Device | 338
Connecting AC Power to an MX2000 Router with Three-Phase Delta AC Power Distribution
Modules | 291
Mapping Input Power from AC Power Distribution Modules to AC Power Supply Modules on MX2000
Routers | 185
Preventing Electrostatic Discharge Damage to an MX2010 Router
Preventing Electrostatic Discharge Damage to an MX2020 Router
Troubleshooting the MX2000 Router Power System
Problem
Description: The following alarms, LEDs, and other conditions indicate a problem with the AC or DC power
system:
320