Juniper MX2010, Hardware Manual

Page: 628 / 825

During normal operations:
•
The green OK LED on the CB-RE faceplate is lit.
•
The red FAIL LED on the CB-RE faceplate is not lit.
•
Issue the show chassis environment cb command to check the status of the CB-REs. The output is similar
to the following:
user@host>
show chassis environment cb
CB 0 status:
State Online Master
IntakeA-Zone0 Temperature 30 degrees C / 86 degrees F
IntakeB-Zone1 Temperature 33 degrees C / 91 degrees F
IntakeC-Zone0 Temperature 37 degrees C / 98 degrees F
ExhaustA-Zone0 Temperature 33 degrees C / 91 degrees F
ExhaustB-Zone1 Temperature 33 degrees C / 91 degrees F
TCBC-Zone0 Temperature 35 degrees C / 95 degrees F
Power 1
1.0 V 1011 mV
1.2 V 1211 mV
1.8 V 1814 mV
2.5 V 2545 mV
3.3 V 3319 mV
5.0 V 5014 mV
5.0 V RE 4962 mV
12.0 V 12123 mV
12.0 V RE 12007 mV
Bus Revision 100
FPGA Revision 270
CB 1 status:
State Online Standby
IntakeA-Zone0 Temperature 30 degrees C / 86 degrees F
IntakeB-Zone1 Temperature 31 degrees C / 87 degrees F
IntakeC-Zone0 Temperature 33 degrees C / 91 degrees F
ExhaustA-Zone0 Temperature 32 degrees C / 89 degrees F
ExhaustB-Zone1 Temperature 31 degrees C / 87 degrees F
TCBC-Zone0 Temperature 34 degrees C / 93 degrees F
Power 1
1.0 V 1008 mV
1.2 V 1211 mV
1.8 V 1798 mV
2.5 V 2520 mV
3.3 V 3312 mV
5.0 V 5020 mV
612