Juniper MX2010, Hardware Manual, Page: 243 / 825

NOTE: The router is maximally protected inside the shipping crate. Do not unpack it until you
are ready to begin installation.
To unpack the router:
1. Move the shipping crate to an ESD-approved staging area as close to the installation site as possible,
where you have enough room to remove the components from the chassis. While the chassis is bolted
to the shipping pallet, you can use a forklift or pallet jack to move it.
2. Position the shipping crate with the arrows pointing up.
3. Open all the latches on the shipping crate.
4. Remove the front door of the shipping crate and set it aside (see Figure 79 on page 225 ).
NOTE: If you ordered a router transport kit, the shipping crate door is used as a ramp to
guide the MX2010 out of the crate.
5. Using a two-person team, slide the remainder of the shipping crate off the pallet.
6. Remove the foam covering the top of the router.
7. Remove the large mounting tray, pallet jack attachment, accessory box, and the Quick Start installation
instructions.
NOTE: If you ordered a router transport kit, see “Unpacking the MX2010 Router Transport
Kit” on page 228
224