Juniper HarvestMaster mirus H2, User Manual

Page: 27 / 130

Mirus for H2 Classic GrainGage
27 Mirus and H2 Classic GrainGage Setup
The following table displays the typical preferred setting for each item on this screen.
System Settings
Item Default Value Description
Debug Streaming
Enabled
No
This enables debug streaming messages for the DSP
module . Enabling this is only recommended when
troubleshooting the GrainGage with a HarvestMaster
Field Service Engineer .
GrainGage Type Classic Designates which GrainGage type is connected to Mirus .
Isolation Gate
Mode
Normally Open
Controls the initial state of the isolation gate . In some
situations, closed is preferred .
Max Sub-Cycle
Count
1
The maximum number of sub-cycles that can be
run during a cycle if the minimum weight threshold
continues to be satisfied .
Override Threshold* No
This bypasses the minimum weight threshold . It allows
for the capture of moisture and test weight data in low
yielding plots .
To calculate M2 .0 Calibration correctly this must be set
to no .
Caution: Changing this setting to Yes risks reduced data
accuracy.
* Contact HarvestMaster Field Service Engineers to change this setting. See 8.4.2 Contact a
HarvestMaster Field Service Engineer on page 128.