Jungheinrich ETX 513, Operating Instructions Manual

Page: 193 / 408

5.3.1 Raising a load unit from the side
Requirements
– Prepare the truck for operation, see page 139 or see page 140.
– Load unit correctly palletised.
– Fork spread for the pallet checked and adjusted if necessary, see page 184.
– Load unit weight does not exceed the truck's capacity.
– Forks evenly loaded for heavy loads.
– Good ground conditions.
Procedure
• Press the deadman button.
• Drive carefully up to the storage location.
• Lower/raise the load handler so that the load can be lifted.
• Do not press the deadman button.
• Slowly insert the forks into the pallet until the fork shank
touches the load or the pallet.
Z
The load unit must not extend by more than 50 mm
beyond the fork tips.
• Press the deadman button.
• Raise the load slightly until it rests freely on the forks.
• Do not press the deadman button.
• Slowly retract the forks to the home position, see
page 182 or see page 183.
• Press the deadman button.
• Make sure you have a clear view and sufficient area to
move in.
• The load can now be transported with the truck, see
page 193.
The load has been lifted correctly.
191
04.19 en-GB