Jungheinrich ETX 513, Operating Instructions Manual

Page: 141 / 408

4.2 Preparing the truck for operation
Switching on the truck
Requirements
– Visual inspections and operations to be
performed before starting daily
operation, see page 124.
– Connect the battery to the truck.
– Insert and lock the battery latch.
– Insert and lock the side panels correctly.
– Close the battery cover, see page 78.
– Enter the operator position, see
page 128.
Procedure
• Turn the EMERGENCY DISCONNECT switch (9) to unlock it.
Z
Press the Emergency Disconnect (9) immediately if the truck starts to move or lift
as soon as it is switched on. Brief steering movements caused by steering
referencing are permissible.
• Switch on the truck, to do this:
• Insert the key in the key switch (8) and turn it as far right as it will go.
• Hold the card or transponder in front of the ISM access module (26) and
depending on the setting press the green button on the ISM access
module (26) (
o
).
8 9 26
Z
The truck is now operational.
The steering is in the straight-ahead position.
139
04.19 en-GB