Jungheinrich ETX 513, Operating Instructions Manual

Page: 226 / 408

Adjusting the steer angle
Requirements
– Fully lower the mast, see page 168 or see page 201.
– Traverse the attachment to the home position (
t
), see page 182.
– Traverse the telescopic table to the centre position (
o
), see page 183.
– Disconnect the battery.
Tools and Material Required
– Allen key (key width 8).
Procedure
• Switch off the truck, to do this:
• Turn the key in the key switch (8) left as far as the stop and remove the key.
• Press the red button on the ISM access module (
o
).
• Press the Emergency Disconnect (9).
• Open the drive compartment cover (95), see page 330.
• Set the drive wheel (31) to the required direction using the Allen key via the
screw (184) at the top of the steer motor.
Z
If you are setting an angle of more than 4 degrees it is advisable to discharge the
drive wheel (31) by raising/jacking up the truck securely.
The steering angle is now set.
WARNING!
Only return the truck to service when you have identified and rectified the fault.
224
04.19 en-GB