Jungheinrich ETX 513, Operating Instructions Manual

Page: 69 / 408

Procedure
• Using a wooden plank, pallet or a rubber mat (89) from the attachment (83) to the
front of the transporter; ensure a positive fit.
• Relieve the drive wheel (31). To do this place the hard wooden blocks (81) under
the chassis on either side at the height of the drive wheel (31).
• Place wedges (78) in front of the load wheels (24) to prevent the truck from
moving accidentally.
CAUTION!
The tie-down straps / tensioning belts must be attached on either side to at least two
different clamp rings (77,82).
WARNING!
Torn tie-down straps / tensioning belts can cause accidents
Tie-down straps / tensioning belts can tear when routed over "sharp" edges.
u Protect the tie-down straps / tensioning belts with a suitable support (69).
u
Do not route the tie-down straps / tensioning belts over "sharp" edges. If this is not
possible, protect the tie-down straps/tensioning belts with a suitable material, e.g.
foam.
u
Protect the tie-down straps/tensioning belts routed over the lift chains with a
suitable material, e.g. foam.
• Guide the tie-down strap / tensioning belt (90) around the "mast receptacle / top
half shell" attachment point (70) and attach it to the clamp rings (77) on either
side.
• Guide the tie-down strap / tensioning belt (76) around the support (73) of the
overhead guard and attach it to the clamp rings (82) on either side.
The truck can now be transported.
67
04.19 en-GB