Jungheinrich ETX 513, Operating Instructions Manual

Page: 264 / 408

8.6
ISM access module (
o
)
Z
If the truck is equipped with an ISM access module or Can Code refer to the “ISM
Access Module” operator manual.
8.7
Rack Height Select (
o
)
To lift or deposit loads in pre-selected storage locations, the truck must be adapted
to the warehouse setup.
Z
The manufacturer's customer service department is specially trained to carry out
these operations.
In addition to the current lift height, the following symbols are shown in the
driver's display:
Symbol
Function
Attachment
Telescopic
table
– Attachment in home position without load
– Attachment in centre position without load
– Attachment in home position with load
– Attachment in centre position with load
– Lowering and lifting an attachment without
load
– Lowering and lifting a telescopic table without
load
– Lowering and lifting an attachment with load
– Lowering and lifting a telescopic table with
load
– Traversing an attachment to the left / right
without load
– Traversing a telescopic table to the left / right
without load
– Traversing an attachment to the left / right with
load
– Traversing a telescopic table to the left / right
with load
– Zone selection
– Area selection
Z
A load sensor between the forks detects whether there is a load on the forks.
262
04.19 en-GB