Jungheinrich ETX 513, Operating Instructions Manual

Page: 181 / 408

• Synchonised fork carriage 90° right rotation and load handler centre traverse:
• Press and hold down on the (104) button under the "Synchronised rotation
until forks in centre position" symbol (169) until the attachment comes to rest
and rotary movement stops.
• Turn the "Hydraulic functions" control lever (113) anti-clockwise until you reach
the centre position.
• Synchonised fork carriage 90° left rotation and load handler centre traverse:
• Press and hold down on the (104) button under the "Synchronised rotation
until forks in centre position" symbol (169) until the attachment comes to rest
and rotary movement stops.
• Turn the "Hydraulic functions" control lever (113) clockwise until you reach the
centre position.
The attachment is in the centre position and the forks are at right angles (90°) to the
truck. Loads can now be lifted from the front.
Z
If the attachment is not in the centre position, you can only travel, lift or lower at
reduced speed, see page 182.
4.14.6
Automatic synchronised rotation until forks are in centre position (
o
)
Z
With "automatic synchronised rotation until forks are in centre position" the fork
carriage is rotated 90° from the home position and the attachment is positioned in
the centre of the traverse/pivot frame.
Requirements
– Prepare the truck for operation, see page 139 or see page 140.
Procedure
• Do not press the deadman button (18).
• Press (104) under the "synchronised rotate menu change" symbol (166).
The display changes from the menu item “Synchronised rotation menu
change” (166) to “Synchronised rotation until forks in centre position” (169).
Z
The rotary and traverse speeds are pre-set. "Synchronised rotation until forks in
centre position" can be cancelled by releasing the (104) button. The attachment
must then be moved manually to the home position.
• Synchonised fork carriage 90° rotation and load handler centre traverse:
• Press and hold down on the (104) button under the "Synchronised rotation
until forks in centre position" symbol (169) until the attachment comes to rest
and rotary movement stops.
The attachment is in the centre position and the forks are at right angles (90°) to the
truck. Loads can now be lifted from the front.
Z
If the attachment is not in the centre position, you can only travel, lift or lower at
reduced speed, see page 182.
179
04.19 en-GB