Jungheinrich ESE 533, Operating Instructions Manual, Page: 72 / 133

Procedure
• Release the magnetic brakes. To do this:
• Disconnect the two-pin connector from both magnetic brakes.
• Screw the screws (2 x M5) into the holes (109) on the magnetic brakes.
Z
Before recovering the truck, the drive wheels can be turned to the required
position via the centre screw of the steering motors using a steering crank (110).
•
110
• Assemble the steering crank (110) in accordance with the tool kit table.
CAUTION!
Tensioned tyres can cause accidents
When steering stationary, the drive wheel tyres are under tension. Releasing the
crank can create a correcting moment.
u Release the steering crank carefully.
Align the drive wheels in turn.
• To do this, place steering cranks (110) one after the other on the steering
transmission and turn the respective drive wheel to the required steering
position.
• Remove the steering crank again before towing.
• Tow the truck to its destination.
The truck has now reached its destination.
72
02.21 en-GB