Jungheinrich ESE 533, Operating Instructions Manual, Page: 117 / 133

Procedure
• Align the drive wheels via the steering drive so that the wheel bolts can be
accessed through the side recesses in the truck frame.
Z
To ensure that all bolts can be accessed, the wheels must be turned in stages.
• Alternatively, the wheel bolts can also be reached after removing the skirt (145)
and the service panel (146). To do this undo the 4 screws from the service
panel and the 5 screws from the skirt (M10 hex. bolts).
• Tighten the wheel bolts on both drive wheels to the specified torque using the
torque wrench.
Z
For torque see table:
• Re-tighten the panel and skirt if necessary.
The wheel attachment is now checked.
117
02.21 en-GB