– 20 –
4. one-touch setting
A part of functon settng tems can be easly changed n the normal sewng state.
(Caution) For the setting of functions other than those covered in this part, refer to
[one-touch setting procedure]
1) Keep
swtch
7
held pressed
for one second to place the panel n
the functon settng mode.
2) Change over the item to be set by
usng
swtch
3
or
swtch
4
. Then, the set value can be
changed by usng
swtch
5
and
swtch
6
.
3) To return to the normal sewng state,
press
swtch
7
.
1
Thread trmmng functon (
)
: Thread trmmng operaton s not performed (solenod output prohbton: Thread trmmer,
wper)
: Thread trmmng operaton s effectve.
2
Wiper function (
)
: Wiper does not operate after thread trimming
: Wiper operates after thread trim
-
mng
3
One-shot automatc sttchng functon (
)
: One-shot automatc sttchng functon s neffectve.
: One-shot automatc sttchng s effec-
tve.
(Caution) this function is rendered effective when the material end sensor function is set. It is not pos-
sible to prohibit the one-shot operation during overlapped sewing operation. the number of
revolution is the value which is set for setting No. 38.
4
Setting of the max. speed of stitch (
)
The hghest speed of sttch of the machne head s set. The upper lmt of the set value dffers wth the
type of machine head to which the SC is connected.
Setting range : 150 - Max. value [sti/min]
5
Materal end sensor functon (
)
: Materal end sensor functon s neffectve.
: Once the materal end s detected, the sewng machne stops runnng after havng sewn the
number of sttches set wth
7
(
).
* Ths functon s rendered effectve when the materal edge sensor s set wth functon settng No. 12.
6
Thread trmmng functon by materal end sensor (
)
: Automatc thread trmmng functon after the detecton of materal end s neffectve.
: Once the materal end s detected, the sewng machne performs thread trmmng after havng
sewn the number of sttches set wth
7
(
).
* Ths functon s rendered effectve when the materal edge sensor s set wth functon settng No. 12.
7
Number of sttches for materal end sensor (
)
The number of sttches to be sewn from the detecton of materal end to the stop of the sewng machne
Number of sttches that can be set: 0 to 19 (sttches)
(Caution) If the number of stitches specified is inadequate, the sewing machine can fail to stop within the
preset number of stitches depending on the number of revolutions of the sewing machine.
(Caution) The setting is confirmed by pressing
switch
7
.
B
A
C
D
6
5
4
3
1
2
7
E
