KE-2050/KE-2060, KE-2050R/2055R/KE-2060R Maintenance Manual
13-15
13-5-3. Setting Up the BIOS
After the HDD has been replaced, check the BIOS. If the settings are different from those described
in <Setting Method>, change the settings appropriately.
Note: BIOS (Basic Input Output System)
The BIOS is an important program necessary to control the data input and output of the
computer (KE2000 in this manual). Therefore, always carefully operate the BIOS.
Normally, the BIOS is saved into the flash memory on the CPU board.
13-5-3-1. Checking the Recognition of the HDD
You may check whether or not the BIOS recognizes the HDD correctly.
If no startable HDD or FDD is found after memory check, a message like the one below will appear.
No bootable device available
R - REBOOT
S - SETUP
You can switch to the BIOS setting screen by pressing the <S> key. (Pressing the <R> key will reset
the unit.)
<Setting Method>
(1) Display the BIOS screen.
Turn on the power, and press the <DEL> key during memory check.
A screen like the one shown below will appear. Locate the cursor to the item you want to
change (the selected item will be highlighted), and press the <Enter> key. The current settings
for the selected item will appear.
Rev. 2.00
