JRC JMR-5410-4X, Instruction Manual

Page: 443 / 688

14-17 Section 14 Adjusting and Setting up Equipment (for Services)
1
14
Table A: Sensors that can be selected by serial ports on RPU
Serial port Sensor name
GPS GPS 1
GPS 2
*1
GPS 3 *1
GPS 4 *1
Gyro Compass Heading Sensor1
Heading Sensor2
NSK
*Since the following combo boxes are enabled when NSK is selected, select a
Heading Sensor to be connected to NSK and Log.
Heading Sensor
Heading Sensor1
Heading Sensor2
Log Log1
Log2
*1 May not be displayed depending on the number of GPS units
[Setting a serial port of built-in SLC]
Set CH1 to CH6 and gyro serial ports that are directly assigned to the display as shown below.
Setting Item Description of Setting Setting Value
CH1 to CH6 1. Select the [RPU] tab.
2. Enable the serial port of the channel by selecting the
check box.
3. Select a sensor *1 to be connected to the channel on
the [Sensor] combo box. When not selecting a
sensor, select [ - ].
To enable: Select.
To disable: Clear.
Gyro 1. Select the [RPU] tab.
2. Enable the serial port of the channel by selecting the
[Gyro] check box.
3. In the [Sensor] combo box, select the sensor to be
connected to the Gyro serial port. When not
selecting a sensor, select [-].
To enable: Select.
To disable: Clear.
Selectable sensors:
Heading Sensor1(NMEA)
Heading Sensor2(NMEA)
*1 The following sensors can be selected on the built-in SLC (CH1 to CH6).
However, the sensors that can be actually selected vary depending on the equipment setting.
AUTO, Heading Sensor 1, Heading Sensor 2, Log 1, Log 2, GPS 1, GPS 2, GPS 3, GPS 4, Ship’s
Clock, Echo Sounder 1, Echo Sounder 2, AIS, NAVTEX, NAVTEX(Japanese), Anemometer, Water
Temperature Metre, Current Metre, Climate Metre, ROT Indicator, Rudder, RADAR1(TT RX),
RADAR2(TT RX), Alert(to BNWAS), GPS/SAT Buoy, WPT(from Plotter)