JRC JMR-5410-4X, Instruction Manual

Page: 276 / 688

Section 6 Target Tracking and AIS 6-32
6.6.2.2 Automatic activation
Activate an AIS target in automatic mode to display the vector and heading line.
When the automatic activation function is used, AIS targets are automatically activated when they go
into the automatic activation zone. The automatic activation zone is identical to the automatic
acquisition zone (AZ) used for target tracking. For the zone setting, refer to "6.5.1.1 Automatic
acquisition ".
Memo
• When the AIS target's symbol is activated but the vector is not displayed, the following are
probable causes of the trouble:
- COG/SOG is not input yet from the GPS.
- The selected speed sensor is malfunctioning.
• The bearing or range in the acquisition/activation zone shall be based on the position of the
radar antenna.
• If there are more AIS targets than the allowable maximum, they are deactivated from the
low-priority (Refer to "6.3 Displaying Symbols").
6.6.3 Deactivating AIS targets
Deactivates an AIS target and clear the display of the vector and heading line.
[Deactivating one AIS target]
1
Right-click on the AIS target to be deactivated.
The setting items for cursor modes are displayed.
2
Click on the [Deactivate] on the Context menu.
The selected AIS target is deactivated.
[Deactivating multiple AIS targets]
1
Right-click on the AIS target.
The setting items for cursor modes are displayed.
2
Click on [Deactivate mode] on the Context menu.
The cursor changes to the selection cursor.
3
Click on the AIS target to be deactivated.
The selected AIS target is deactivated.
Memo
This operation is available only for an activated AIS target.