JRC JMR-5410-4X, Instruction Manual

Page: 343 / 688

10-11 Section 10 Creating a User Map
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
10.5.5 Creating an object in the EBL/VRM mode
1
Click on the [EBL/VRM] button on the drawing toolbar.
The user map creation function mode is switched from the cursor mode to the EBL/VRM mode.
When the mode is switched to the EBL/VRM mode, the cursor changes to the following state.
The EBL/VRM mode is switched to cursor mode when the right mouse button is clicked on the
chart or the [Enter POSN] button on the drawing toolbar is clicked on.
10.5.6 Creating an object by specifying latitude and
longitude
Using the [Enter Position] dialogue, it is possible to create an object at the specified latitude and
longitude.
Displaying the [Enter Position] dialogue
1
Click on the [Enter POSN] button on the drawing toolbar.
Memo
An object cannot be created with the cursor mode and EBL/VRM mode while this dialogue
is displayed.
10.5.6.1 Creating an object of Mark/Text
Enter latitude and longitude values of the object in the [Position] box and click on the [Enter] button.
The [Bearing] box, [Distance] box, and the [New] button are disabled.
10.5.6.2 Creating an object of Line
Use the following procedure to create an object with vertices such as Line.
1
Enter latitude and longitude values of a vertex of the object in the [Position] box and
click on the [Enter] button.
The position of one of the vertices of the object is determined.
The [Bearing] box and the [Distance] box are enabled.
2
Enter latitude and longitude values of the next vertex in the [Position] box.
Alternatively, enter the bearing and distance from the previous vertex that was
determined in the [Bearing] box and the [Distance] box.
3
Click on the [Enter] button.
4
Repeat Steps 2 and 3.
A line can be determined by two or more vertices.
5
To create an object continuously on another position, click on the [New] button.
EBL/VRM base point cursor