JRC JMR-5410-4X, Instruction Manual

Page: 243 / 688

5-29 Section 5 Basic Operation of the Radar
1
2
3
4
5
5
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
APP A
APP B
1
5.4.14 Setting own ship speed
5.4.14.1 Switching own ship speed device
1
Select the ship speed device from the [STW] combo box of own ship’s information.
Memo
• When using 1-axis log, heading speed component can be detected, but transverse speed
component cannot be detected. Then leeway effect (component drifted by wind) cannot be
detected.
• When using 2-axes ground log, its accuracy in shallow waters may be deteriorated, and its
speed in deep sea areas may be unable to be detected.
• When using a GPS, COG accuracy is less than ±3° at speed: from 1kn to 17kn, and is less
than ±1° at speed: more than 17kn.
5.4.14.2 Entering the ship’s heading/own ship’s speed
manually
If any of the devices connected to this equipment (example: Log) malfunctions, use the following
procedure to input the ship’s heading/own ship’s speed so as to make the target tracking device and
the true motion display available.
1
Select [Menu] from the corresponding combo box.
The [Sensor Selection/Status] dialogue box is displayed.
2
To input ship’s heading manually, select [MAN] from the [HDG] combo box. To input
own ship’s speed manually, select [MAN] from the [STW] combo box.
3
Click on the input box.
4
Enter a numeric value by using the software keyboard.