JR ProPo XG11MV, Operation Manual

Page: 9 / 136

7
▋ Notes▋on▋stick▋tension▋spring▋adjustment▋and▋the▋
throttle▋stroke▋travel▋adjustment▋plate
▋
▋
This▋allows▋adjustment▋of▋the▋
stick▋spring▋strength.
① Be certain to remove the battery before carrying
out any adjustments.
② Remove the screws in the six (6) locations on
the rear case.
③ Adjust the springs to the desired spring tension.
By carefully adjusting each of the screws, you
can achieve a range of spring tensions.
④ Close the rear cover, and tighten the screws.
Take care of the interlocking of levers, etc.
If you prefer a ratchet on the throttle, replace
the spring plate as shown in the drawing on the
left at the bottom of this page.
The drawing on the right shows the default
setting, giving a smooth throttle transition.
Never Touch the Printed Circuit Board or
any related parts inside the transmitter.
Note the following figures show a mode 1
transmitter.
Screws x 6
For the Throttle
For the Aileron
For the Elevator
For the Rudder
Screw to secure spring
Screw for spring adjustment
For Airplane For Helicopter
※ Touching the board may result in electric shock, uncontrolled microcomputer operation, or
damage to model data, and normal operation may become impossible.
Detail of this area.
Screw to secure spring
Screw for spring adjustment
※Ratchet operation ※Smooth operation
Direction of
the spring
Direction of
the spring
Direction of
the spring
Direction of
the spring
supporting surface supporting surface
CONVEX
Preparation