JR ProPo XG11MV, Operation Manual

Page: 8 / 136

6
▋ Inserting▋and▋Removing▋the▋Transmitter▋Battery
1) While pressing the embossed mark on the rear surface of the battery lid, slide the lid in arrowed direction of the
arrow, and remove.
2) Carefully insert the rechargeable battery connector into the transmitter battery connector.
3) Fit the rechargeable battery into the battery box together with filling sponge, and mount the battery cover, taking
care not to pinch the lead wires.
▋
Charging▋the▋Transmitter▋Battery
Before charging the battery, be certain to read the precautions written on the battery label.
The transmitter operates exclusively with genuine JR Li-Fe batteries. Do not use the transmitter with other
rechargeable batteries or with dry cell batteries.
During charging, the transmitter should be switched off. When the transmitter ON, charging will not take place.
※ Note that if using a flight simulator with the control cable plugged into the trainer jack (and the power switch
OFF on the transmitter), it is possible to plug the charge cable into the transmitter and use the AC adaptor to
supply power. Since the built-in battery will not be used, this will allow enjoyment while conserving energy.
1) Insert the AC adaptor into the AC electric power socket.
Insert the plug from the AC adapter into the charger. Then insert the plug from the charger into the DC power
jack of the transmitter.
If the LED on the back side of the transmitter does not illuminate, an error may have occurred. In this situation,
detach the AC adapter plug, and re-insert it. If the back side LED does not light even after the cable has been
removed and inserted several times, please contact your JR agent or distributor in your country.
2) During charging, the LED located on the back-side of transmitter will light. When charging is complete, the LED
will switch off. The standard charging time is approximately 3 hours.
3) After charging has been completed, promptly detach all the connections. Absolutely do not leave the charger
connected to the transmitter.
※ Be certain to only use the genuine JR XG11mv dedicated AC adapter (NEC-A1530) and charger (NEC-J17C).
Charging cannot be carried out using other AC adapters or chargers. Further, do not use this AC adapter or
charger for charging products other than the XG11MV.
DANGER
CAUTION
Helicopter
Airplane
Glider
WARNING
Warning！Abnormal heat generation may cause explosion of the battery!
After charging is complete, detach all of the connections including the AC adaptor from the outlet.
Never leave the AC adaptor connected to the transmitter or plugged into the AC outlet. This is to avoid possible
fire risk after charging the battery.
Do not use the AC adapter while the cord is still bundled together,
since there will be a risk of heat generation.
Li-fe Battery
Recharging Power Source jack
To the Recharging
Power Source jack
To Charger
NEC-J17C OUTPUT TX DC1
1V 500mA
Charger NEC-J17C
Battery connector
Battery box
Battery cover
AC Adaptor NEC-A1530
To AC Electric Power Outlet
When removing the
connector, press the
lever part to release
the lock while pulling
out the connector.
DANGER
CAUTION
Helicopter
Airplane
Glider
WARNING
Li-fe Battery
Recharging Power Source jack
To the Recharging
Power Source jack
To Charger
NEC-J17C OUTPUT TX DC1
1V 500mA
Charger NEC-J17C
Battery connector
Battery box
Battery cover
AC Adaptor NEC-A1530
To AC Electric Power Outlet
Preparation