Johnson Controls York MaxE YK Series, Manual

Page: 65 / 139

JohNSoN CoNtroLS
2
ForM 160.75-N1 (309)
iMPortant!
rEad BEforE ProcEEding!
gEnEral safEtY guidElinEs
This equipment is a relatively complicated apparatus. During installation, operation maintenance or service, individuals
may be exposed to certain components or conditions including, but not limited to: refrigerants, oils, materials under
pressure, rotating components, and both high and low voltage. Each of these items has the potential, if misused or
handled improperly, to cause bodily injury or death. It is the obligation and responsibility of operating/service personnel
to identify and recognize these inherent hazards, protect themselves, and proceed safely in completing their tasks.
Failure to comply with any of these requirements could result in serious damage to the equipment and the property
in which it is situated, as well as severe personal injury or death to themselves and people at the site.
This document is intended for use by owner-authorized operating/service personnel. It is expected that this individual
posseses independent training that will enable them to perform their assigned tasks properly and safely. It is essential
that, prior to performing any task on this equipment, this individual shall have read and understood this document and
any referenced materials. This individual shall also be familiar with and comply with all applicable governmental
standards and regulations pertaining to the task in question.
safEtY sYMBols
The following symbols are used in this document to alert the reader to areas of potential hazard:
CAUTION identifies a hazard which
could lead to damage to the machine,
damage to other equipment and/or
environmental pollution. Usually an
instruction will be given, together with
a brief explanation.
NOTE is used to highlight additional
information which may be helpful to
you.
DANGER indicates an imminently
hazardous situation which, if not
avoided, will result in death or seri -
ous injury.
WARNING indicates a potentially
hazardous situation which, if not
avoided, could result in death or seri -
ous injury.
changEaBilitY of this docuMEnt
In complying with Johnson Controls policy for continuous product improvement, the information contained in this
document is subject to change without notice. While Johnson Controls makes no commitment to update or provide
current information automatically to the manual owner, that information, if applicable, can be obtained by contacting
the nearest Johnson Controls Service office.
It is the responsibility of operating/service personnel to verify the applicability of these documents to the equipment in
question. If there is any question in the mind of operating/service personnel as to the applicability of these documents,
then prior to working on the equipment, they should verify with the owner whether the equipment has been modified
and if current literature is available.