SECTION 5 - EMERGENCY PROCEDURES
3121773
– JLG Lift –
5-13
5.4
SAFETY DEVICES BYPASS KEY USE
THIS FEATURE MUST ONLY BE USED AS DESCRIBED BELOW. THE MACHINE
COULD TIP OVER IF THESE DIRECTIONS ARE NOT FOLLOWED.
The machine has a key for bypassing the platform safety sys-
tems. The safety device bypass switch is located at the left
rear in the electronics cabinet inside the access hatch. The
key used to activate the safety device bypass switch, is fas-
tened to the cover attach screw mounting tab from the fac-
tory, on the right side - hand pump/valve components
compartment - near the platform.
1
Remove key and insert it into the bypass key
switch (item 1 - photo). After using the safety
device bypass, a qualified JLG mechanic must be
contacted to determine the reason for needing
to use this feature. Return the key to the where you found it
and secure it in that location.
The safety device circuit board records every time the safety
device bypass key is activated along with the movements
made during these operations.
NOTE:
In case of machine with restricted area of operation,
the bypass of the safety devices does not allow the
boom assembly to go out of the safe working area.
SAFETY DEVICE BYPASS ALLOWS OPERATION OF MACHINE WITH AN OVER-
LOAD IN THE PLATFORM. THE OVERLOAD ALARM WILL SOUND AND THE
OVERLOAD ICON WILL BE ON THE PLATFORM/REMOTE CONTROL BOX DIS-
PLAY. REMOVE OVERLOAD FROM THE PLATFORM BEFORE OPERATION.
To
order
go
to
Discount-Equipment.com
