SECTION 6 - GENERAL SPECIFICATIONS AND OPERATOR MAINTENANCE
3121773
– JLG Lift –
6-17
NOTE:
Re-charge voltage should never exceed 14.7 volts and
the load intensity shall be 0.2% of the value indicated
below and on the lid of the battery.
4.
When charging is completed turn off the battery
charger before disconnecting the cables from the
battery poles
5.
Return the terminal clamps to the battery poles
and lubricate with the appropriate product
6.
Close battery cover.
IT IS GOOD PRACTICE TO AVOID PRESSURE-WASHING ELECTRICAL/ELEC-
TRONIC COMPONENTS. IN THE EVENT PRESSURE-WASHING THE MACHINE IS
NEEDED, ENSURE THE MACHINE IS SHUT DOWN BEFORE PRESSURE-WASH-
ING. SHOULD PRESSURE WASHING BE UTILIZED TO WASH AREAS CONTAIN-
ING ELECTRICAL/ELECTRONIC COMPONENTS, JLG INDUSTRIES, INC.
RECOMMENDS A MAXIMUM PRESSURE OF 750 PSI (52 BAR) AT A MINIMUM
DISTANCE OF 12 INCHES (30.5 CM) AWAY FROM THESE COMPONENTS. IF
ELECTRICAL/ELECTRONIC COMPONENTS ARE SPRAYED, SPRAYING MUST
NOT BE DIRECT AND BE FOR BRIEF TIME PERIODS TO AVOID HEAVY SATURA-
TION.
6.4
ELECTRIC MOTOR MAINTENANCE
Periodically check the condition of the following electric
motor components.
Electric Motor
The electric motor is located inside of the rear hydraulic
valve distributor support cover.
•
POWER SUPPLY TERMINALS
Check tightness of the nuts on the power supply
terminals and make sure the insulation is intact.
•
FAN
Keep air intakes clean and make sure the fan can
rotate freely.
•
BEARINGS
Check the condition of the bearings, in the event
of noise contact JLG for replacement, the life of the
bearings is reduced significantly in heavy duty
operating conditions.
NOTE:
This motor is "brushless" therefore no brushes need to
be checked or replaced.
To
order
go
to
Discount-Equipment.com
