Jersey Jack Pinball Pirates of the Caribbean, Operation Manual

Page: 19 / 359

Game Assembly & Setup A-7
2
3
5
1
4
Figure A9. Removing the playfield glass.
Figure A10. Playfield in the game play position.
and adjusting the leg levelers and tightening nuts accordingly. When finished, secure
the tightening nut against the underside of each leg.
12)
Your Jersey Jack Pinball® playfield is designed to rest in four distinct positions in
its cabinet for game play, cleaning and maintenance. Figure A10 shows the playfield
in its standard position.
11)
Locate the game’s five pinballs in the loose parts. Wipe the balls with a soft rag
to remove any anti-rust compounds before use. Place all five balls in the ball trough
(drop them onto the playfield, below the flippers, and allow them to drain). Level the
game side-to-side by placing a bubble level on the playfield surface (top and bottom)
10)
You will find the coin door keys attached to the ball shooter, on the front of
the game. Cut them loose with a pair of wire cutters. Remove the playfield glass:
1) open the coin door, 2) slide the yellow lockdown bar lever to the left, 3) lift the
lockdown bar straight up and out, 4) CLOSE AND LOCK THE COIN DOOR (to prevent
scratching of playfield glass), then 5) slide the playfield glass off of the front of the
cabinet (see figure A9). Carefully set the glass aside. CAUTION: Lay the playfield
glass flat or on a padded surface. NEVER place playfield glass, on edge, on a hard
surface! The tempered glass could shatter!