Jeep Gladiator 2021, Owner'S Manual

Page: 108 / 484

106 GETTING TO KNOW YOUR VEHICLE
nearest the desired location. Make sure the
utility rail cleat is seated in the detent, and
tighten the nut.
To remove the utility rail cleats from the side
utility rails, slide the cleat to the rectangular
cutout located at the end of the rail toward the
front of the vehicle.
To remove the utility rail cleat from the front
utility rail, slide the cleat to the rectangular
cutout located on the left side of the rail.
TONNEAU COVER — IF EQUIPPED
The Tonneau Cover can be installed on the
truck bed to keep cargo out of view, and protect
from inclement weather.
The Tonneau Cover consists of the following
features:

Easy roll up cover

Tonneau fore/aft locator

Crossbar inside bed locator

Rear latches

Stowage straps
NOTE:
The Tonneau Cover can be rolled up and
secured at the front of the truck bed without
removing it completely.
T
ONNEAU
C
OVER
I
NSTALLATION
To install the Tonneau Cover, proceed as
follows:
1. Position the rolled up Tonneau Cover on
the truck bed and align it to the two
fastener locations at the front of the bed.
Fastener Locations
2. Using a #T50 Torx head driver, secure the
fasteners to the bed.
3. Lower the tailgate to the fully open position
before unrolling the Tonneau Cover.
4. Release the stowage straps used to secure
the Tonneau Cover in the rolled up position.
Release Stowage Strap
5. Roll the Tonneau Cover rearward toward the
back of the truck bed.
Roll Tonneau Cover Rearward