Jeep Gladiator 2021, Owner'S Manual, Page: 183 / 484

STARTING AND OPERATING 181

The Electronic Stability Control/Traction
Control System (ESC/TCS) activates

The vehicle parking brake is applied

A Trailer Sway Control (TSC) event occurs

The driver switches ESC to Full Off mode.

The vehicle speed is less than 15 mph
(24 km/h) (manual transmission only)

The clutch is pressed for more than
10 seconds (manual transmission only)

The vehicle is placed in NEUTRAL for more
than 10 seconds (manual transmission only)

The driver shifts to FIRST gear (manual trans -
mission only)
The following conditions will only cancel the ACC
system:

Driver seat belt is unbuckled at low speeds

Driver door is opened at low speeds
To Turn Off
The system will turn off and clear the set speed
in memory if:

The Adaptive Cruise Control (ACC) on/off
button is pushed

The Fixed Speed Cruise Control on/off button
is pushed

The ignition is placed in the OFF position

4WD Low is engaged
To Resume
If there is a set speed in memory push the RES
(resume) button and then remove your foot
from the accelerator pedal. The instrument
cluster display will display the last set speed.
Resume can be used at any speed above
20 mph (32 km/h) when only Fixed Speed
Cruise Control is being used.
Resume can be used at any speed above 0
mph
(0 km/h) when ACC is active.
NOTE:

While in ACC mode when the vehicle comes to
a complete stop longer than two seconds, the
system will cancel. The driver will have to apply
the brakes to keep the vehicle at a standstill.

ACC cannot be resumed if there is a
stationary vehicle in front of your vehicle in
close proximity.
To Vary The Speed Setting
To Increase Or Decrease The Set Speed
After setting a speed, you can increase the set
speed by pushing the SET (+) button, or
decrease speed by pushing the SET (-) button.
U.S. Speed (mph)

Pushing the SET (+), or SET (-) button once
will result in a 1 mph speed adjustment. Each
subsequent tap of the button results in an
adjustment of 1 mph.

If the button is continually pushed, the set
speed will continue to adjust in 5 mph incre -
ments until the button is released. The new
set speed is reflected in the instrument
cluster display.
WARNING!
The Resume function should only be used if
traffic and road conditions permit. Resuming
a set speed that is too high or too low for
prevailing traffic and road conditions could
cause the vehicle to accelerate or decelerate
too sharply for safe operation. Failure to
follow these warnings can result in a collision
and death or serious personal injury.
4