33
IT - Risoluzione dei problemi
Problema
Causa
Soluzione
Modello non risponde
Batterie scariche o difettose
caricare, sostituire le batterie
Motore difettoso
sostituire il motore
cavi allentato o danneggiato
Ricollegare o sostituire i cavi
Trasmettente spenta, danneggiato o perso il binding
Accendere la trasmittente o rieffettuare il bin-
ding
Ricevente diffettoso
Sostituire la ricevente
Regolatore di velocità difettoso oppure non
correttamente collegato
Sostituire oppure ricollegare il regolatore
Modello reagisce in maniera incontrollata
Trasmettente spenta, danneggiato o perso il binding
Sender einschalten, neu binden oder ersetzen
Regolatore programmato non correttamente
Riprogrammare il regolatore
Ricevente diffettosa
Sostituire la ricevente
Motore reagisce in modo strano appena ac-
ceso la trasmittente
Fail Safe male impostato
Riprogrammare il Fail Safe
Trim del Gas non in posizione neutrale
Trimmare il Gas
Modello va solo in avanti
Regolatore programmato non correttamente
Riprogrammare il regolatore
Reagisce solo il sterzo ai comandi
Regolatore oppure motore diffettoso
Sostituire il regolatore oppure motore
Sterzo non risponde
Servo sterzo diffettoso
Sostituire il servo sterzo
Dualrate non impostato correttamente
Impostare Dualrate
Leva del sterzo sporco
Pulire la leva del dterzo
Forte rumore dalla trasmissione
Ingranaggio principale, pignone o differenziale
danneggiati
non continuare la guida!
Sostituire la parte difettosa
Distanza pignone corona non impostata bene
Controllare il giocho tra pignone - corona
Regolatore di velocità si spegne durante la
guida
Blocco della sottotensione, tensione batteria bassa
Caricare la batteria
Spegnimento per temperatura eccessiva
Fare raffreddare il regolatore di velocità
Perdita dei cardani anteriore
Larghezza carreggiata elevata
Riduree la distanza
GB - Troubleshooting
Problem
Possible cause
Solution
Model does not respond
Battery or batteries empty or defective
Charge battery or replace
Motor broken
Replace motor
Loose or damaged cable
Reconnect cable or replace
Transmitter turned off, lost or damaged binding
Transmitter back on, bind or replace
Defective receiver
Replace receiver
Speed controller is defective or connection issue
Connect properly or replace
Model react uncontrolled
Transmitter turned off, lost or damaged binding
Transmitter back on, bind or replace
Controller not calibrated or programmed incorrectly
Recalibrate or reprogram
Defective receiver
Replace receiver
Engine is running when you turn on
inadvertently
Incorrectly set Failsafe
Failsafe program to neutral
Throttle trim on the transmitter is not in neutral
Throttle trim set to neutral
Model moves forward only
Controller not calibrated or programmed incorrectly
Recalibrate or reprogram
Only steering response
Regulator or Motor is defective or not Calibrated
Calibrate speed controller or replace motor
Steering does not respond
Power steering defect
Replace servo
Dual Rate on the transmitter set too low or to 0
Dual rate increase
Very dirty steering lever or steering knuckle
Clean and lubricate well
Loud noise from the drive
Main gear, pinion or differential damage
Do not continue! affected part needs to be
replaced
Incorrect gear mesh
Reset gear mesh
Speed controller shuts off while driving
Low voltage cut-off, battery voltage too low
Charging the battery
Overtemperature
Let speed controller cool
Front drive shafts fall out
Too large track width
Track width reduction