JAI PULNiX TM-4100GE, Operation Manual

Page: 36 / 71

Page 26
GigE Series Camera Serial Commands
TM-4100GE Software
5 GigE Series Camera Serial Commands
You can control the GigE series cameras by serial command either using RS-232 or Camera Link. The
Start character is always “:” and the End character is always <CR> (return). For example, to set
Asynchronous Pulse Width Mode, send the command :ASH=9<CR> to the camera. Table 4 lists serial
commands that can be used to control the camera.
TABLE 4.
TM-4100GE Command List
Command Parameters
End of
Command
Ack Response Description
Gain Control
:MGA= DDD <cr> :o<cr> Set CDS gain for ch A (DDD = 042 ~ 1E8)
:MGB= DDD <cr> :o<cr> Set CDS gain for ch B (DDD = 042 ~ 1E8)
:MGA? <cr> :oGA[DDD]<cr> Enquire CDS gain for ch A
:MGB? <cr> :oGB[DDD]<cr> Enquire CDS gain for ch B
:EABL <cr> :o<cr> Enable auto gain balance
:DABL <cr> :o<cr> Disable auto gain balance
:ABL? <cr> :oAB[N]<cr>
Check if auto gain balance is enable (N = 1
Enable, N = 0 : Disable)
ADC Reference Voltage Control
:VRA= DDD <cr> :o<cr>
Set reference voltage for ch A (XXX = 000
~ 1FF)
:VRB= DDD <cr> :o<cr>
Set reference voltage for ch B (XXX = 000
~ 1FF)
:VRA? <cr> :oVA[DDD]<cr> Enquire reference voltage for ch A
:VRB? <cr> :oVB[DDD]<cr> Enquire reference voltage for ch B
Shutter Control
:MSH= S <cr> :o<cr> Set Manual shutter (S = 0 ~ 9)
:DSH= DDD <cr> :o<cr>
Set Direct shutter (DDD = 000 ~ XXX
*
)
:ASH= S <cr> :o<cr> Set Async shutter (S = 0 ~ 9)
:ADS= DDD <cr> :o<cr> Set Async Direct Shutter (DDD=000-81F)
:SHR? <cr> :o[shtr]<cr> Enquire current shutter mode and number