JAI PULNiX TM-4100GE, Operation Manual

Page: 37 / 71

Page 27
GigE Series Camera Serial Commands
TM-4100GE Software
Note: If a command is not accepted for any reason, the camera will return a Nack response “:e”<cr>
Report Command: RPST<cr>
TS Return : O RR + “24 bytes” + <cr>
Lookup Table
:GM45 <cr> :o<cr> Set gamma (.45) table
:LINR <cr> :o<cr> Set linear table
:KNEE= X1Y1X2Y2 <cr> :o<cr> Set knees (X1, Y1, X2, Y2 = 00 ~ FF)
:SLUT N <cr> :o<cr>
Set positive knee or negative knee (N = 0 :
positive,
M = 1 : negative)
:LUT? <cr> :o[lut]<cr> Enquire current LUT setting
Memory Pages
:WRPG N <cr> :o<cr>
Write Page N (N = 0 ~ 6; Page 0 is factory
setting and not allowed to change by cus-
tomer)
:LDPG N <cr> :o[settings]<cr> Load Page N (N = 0 ~ 6)
:RDPG N <cr> :o[settings]<cr> Read (Report) Page N (N = 0 ~ 6)
Scan Mode
:SMD M <cr> :o<cr> Set Mode (M = A, B, C, D)
:SMD? <cr> :oMD[mode]<cr> Enquire current scan mode
Miscellaneous
:RPST <cr> :o[settings]<cr> Report Current Overall Settings
:TPTN N <cr> :o<cr>
Enable/Disable Test Pattern (N = 1 :
Enable,
N = 0 : Disable)
:CAM? <cr> [CamMode] Enquire Camera Model
:VER? <cr> [version] Enquire current version of firmware
*. Maximum size is equal to the maximum line number of each scan mode.
TABLE 4.
TM-4100GE Command List (Continued)
Command Parameters
End of
Command
Ack Response Description