JAI PULNiX TM-4100GE, Operation Manual

Page: 26 / 71

Page 16
Configuring the TM-4100GE Camera
TM-4100GE Software
3.4.6 Look-Up Table
The look-up table (LUT) control, shown in Figure 18, allows you to change two knee point values.
FIGURE 18. Look-Up Table
Enter X
1
, Y
1
, X
2
, Y
2
values directly to adjust the knee curve. In the integrated camera software, the
look-up table can also be controlled interactively. The Table Selection pull-down menu allows you to
select the Linear or Gamma 45 option. This control also allows you to check the positive or negative
box to choose an image option.
3.4.7 Memory Pages
All the camera parameters such as shutter mode, shutter speed, gain, offset level, scan mode, and LUT
can be saved into seven available memory pages on the EEPROM in the camera. The pages are
numbered 0-6. The Load Page button loads the corresponding camera settings from the EEPROM while
the write page button writes the current camera settings to the corresponding memory page in the
EEPROM.
Page 1, shown in Figure 19, is the power-up default page. Page 0 is the factory default. To save your
current camera settings for power up default, write the settings to memory page 1.
FIGURE 19. Memory Pages
To reset memory page 1 to the factory default settings, load memory page 0 and save those settings to
memory page 1. Page 0 is password-protected and you cannot write to it. If you find that you do need to
write to page 0, contact JAI PULNiX for password access.