Pro II: Multi-IO Modules
Pro II-MIO-4-ET1 Rev. E
ADwin
38
ADwin-Pro II
Hardware, manual Dec. 2018
Output current
max. ±24mA per channel, max. ±50mA per block
(4 channels) via V
CC
or GND
Event input
TTL Logic
Power up status
All channels as inputs
Transistor Outputs
Output channels
4
Switching voltage V
CC
5…30V DC durch externe Spannungsversorgung
Switching current
200mA max. per channel
Voltage drop
0.5V
Switching time
2.5µs
Isolation
42V channel-channel / channel-GND
common ground for all OPT and TRA channels
Optocouple Inputs
Input channels
4
Input current
typ. 3.5mA / max. 7.5mA
Input voltage range
(selectable via jumpers)
0…5V / 0…12V / 0…24V
Switching threshold for
0-low
0…0.8V / 0…1.6V / 0…3.2V
Switching threshold for
1-high
4.5…5V / 10…12V / 20…24V
Input over-voltage
-5V … 8V / -5V … 16V / -5V … 30V /
Switching time
100ns
Isolation
42V channel-channel / channel-GND
common ground for all OPT and TRA channels
Counter
Number
1 universal counter block
Counter resolution
32 bit
Reference clock
50MHz
Clock frequency four
edge evaluation
12.5MHz max. (at 90° phase-shift of the signals)
C l o c k f r e q u e n c y
up/down counter
15MHz max.
Reference frequency
PWM analysis
100MHz
Input / output level
compatible to RS422/485 (5V differential, 120
Ω
bus termiinating resistor)
Isolation
none
SSI Decoder
Number
1
Clock frequency SSI
deccoder (CLK)
6kHz … 12.5MHz
Ethercat Interface
Number
1, to be programmed in
TiCoBasic
General
Fig. 29 – Pro II-MIO-4-ET1 Rev. E: Specification