Jäger ADwin-Pro II, System And Hardware Description

Page: 16 / 231

Setting the module’s addresses (Pro I modules, too)
ADwin
12
ADwin-Pro II Hardware, manual Dec. 2018
Setting the module’s adress: Pro I modules
With Pro I modules, you set the module address manually via DIP-switches.
The on-board block of DIP-switches is located right to the bottom.
Wit 8 DIP switches the address is selectable between 1 and 255 (see fig. 12).
Each module of the same group needs to have a different address.
Please note:
– A RSxxx module with 4 serial interfaces uses 2 addresses (group EXT):
the set address and the following address.
– A fieldbus module uses 32 addresses (group EXT); the address alloca-
tion is shown in fig. 13.
Module no.
Settings of DIP switches
1 2 3 4 5 6 7 8
1 1 0 0 0 0 0 0 0
2 0 1 0 0 0 0 0 0
3 1 1 0 0 0 0 0 0
4 0 0 1 0 0 0 0 0
5 1 0 1 0 0 0 0 0
6 0 1 1 0 0 0 0 0
7 1 1 1 0 0 0 0 0
8 0 0 0 1 0 0 0 0
… …
254 0 1 1 1 1 1 1 1
255 1 1 1 1 1 1 1 1
Fig. 12 – Address settings of the ADwin-Pro modules with DIP switches
ON
1 2 3 4 5 6 7 8
A0 A1 A2 A3 A4 A5 A6 A7
ON
1 2 3 4 5 6 7 8
DIP-switch block
Set module
address
Addit. allocated
addresses
Settings of DIP switches
1 2 3 4 5 6 7 8
1 160…191 1 0 0 0 0 0 0 0
2 192…223 0 1 0 0 0 0 0 0
3 224…255 1 1 0 0 0 0 0 0
4 128…159 0 0 1 0 0 0 0 0
Fig. 13 – Address settings of fieldbus modules with DIP switches