ADwin-Pro II
Hardware, manual Dec. 2018
129
Pro II: Digital-I/O Modules
Pro II-REL-16 Rev. E
ADwin
Programming
The module is comfortably programmed with
ADbasic
instructions. The
instructions are described in
ADbasic
online help and in the Pro II Software
manual.
The include file
ADwinPro_All.inc
contains instructions for the following
functions:
Output channels
16
Switch voltage
30V AC/DC Maximum
Switch current
max. 500mA per channel
Contact
1 per channel, normally open
(optional: normally closed)
Operate time
4ms
Release time
3ms
Bounce time
2ms
Event inputs
1
Isolation
42V channel-channel / chan-
nel-GND
Event input voltage
5V, 12V, 24V
(selectable via jumpers)
Power up status
low
(normally open contact: open /
normally closed contact: closed)
Connector
37-pin D-Sub female connector
Fig. 114 – Pro II-REL-16 Rev. E: Specification
Function
Instructions
Set and read back output sig-
nals
P2_Digout
,
P2_Digout_Long
P2_Digout_Bits
P2_Get_Digout_Long
Use latch register
P2_Dig_Latch
,
P2_Dig_Write_Latch
Synchronize
P2_Sync_All
,
P2_Sync_Enable
P2_Sync_Stat
Use LED
P2_Check_LED
,
P2_Set_LED
Use interrupt and event inputs
P2_Event_Enable
,
P2_Event_Read
P2_Event_Config