Processor modules
Pro-CPU-T11-ENET
ADwin
14
ADwin-Pro II
Hardware, manual Dec. 2018
5.3.1 Pro-CPU-T11-ENET
The processor modul can only be run in a Pro II casing and works both with
Pro I and Pro II modules.
The output module Pro-AOut-x runs with T11 up from Rev. B.
For this module, there are several ordering options Pro II-Boot with Storage
Device, which provide access to a storage device. For example, the device
enables data storage in stand-alone operation of the
ADwin
system for
long-term measurement.
The additional properties of the options are described on page 19.
The processor module has a fixed position in the casing. Please see the notes
on how to Plug-in a module on page 4.
The internal memory of the processor is divided into program memory (PM),
data memory (DM) and free-for-use extra memory (EM). Each memory section
has a size of 256 KiB.
Fig. 15 – Pro-CPU-T11-ENET: Front panel
The processor module show the mode of operation by LEDs at the Ethernet
connector. The meaning of the LEDs is described in manual ADwin Installation,
chapter 10.5.
To be used for Pro system
Pro II
Processor
ADSP TS101S
Clock rate
300MHz
Calculation resolution for float
values
40 Bit
Data connection
Ethernet
Interface ENET-2, up to 100 MbBit/s
Interface ENET-3 (since Rev. E10),
up to 1000 MbBit/s
Internal memory
PM: 256 KiB, DM: 256 KiB, EM: 256 KiB
External memory
256MiB
TTL-signal inputs
Event In, with 4,7k
Ω
pull-down resistor
Dig I/O 0, with 4,7k
Ω
pull-up resistor
Dig I/O 1, with 4,7k
Ω
pull-up resistor
Fig. 14 – Pro-CPU-T11-ENET: Specifikation
CPU-T11
ADwin-Pro
DIG I/O 0
EVENT IN
ST
BU
AC
LI
ET
HERNET
DIG I/O 1
CPU-T11
ADwin-Pro II
DIG I/O 0
EVENT IN
ST
BU
ETHERNET
DIG I/O 1
T11
ENET-2
T11
ENET-3
