Jaden DLB1-0D40S2G, Instruction Manual

Page: 173 / 173

-173-
•
Do not change the default settings of the Inverter. Failure tocomply will result in damage to the
Inverter.
Ø
During operation
•
Do not touch the fan or the discharging resistor to check thetemperature. Failure to comply will
result in personal burnt.
•
Signal detection must be performed only by qualified personnelduring operation. Failure to
comply will result in personal injuryor damage to the Inverter.
•
Avoid objects falling into the Inverter when it is running. Failureto comply will result in damage
to the Inverter.
•
Do not start/stop the Inverter by turning the contactor ON/OFF.Failure to comply will result in
damage to the Inverter.
thomas@cn-JADEN; Skype: thomas.lt65
Ø During maintenance
•
Repair or maintenance of the Inverter may be performed onlyby qualified personnel. Failure to
comply will result in personalinjury or damage to the Inverter.
•
Do not repair or maintain the Inverter at power-on. Failure tocomply will result in electric shock.
•
Repair or maintain the Inverter only ten minutes after the Inverter is powered off. This allows for
the residual voltage in thecapacitor to discharge to a safe value. Failure to comply willresult in
personal injury.
•
Ensure that the Inverter is disconnected from all power suppliesbefore starting repair or
maintenance on the Inverter.
•
Set and check the parameters again after the Inverter isreplaced.
•
All the pluggable components must be plugged or removed onlyafter power-off.
•
The rotating motor generally feeds back power to the Inverter.As a result, the Inverter is still
charged even if the motorstops, and the power supply is cut off. Thus ensure that the Inverter is
disconnected from the motor before starting repair ormaintenance on the Inverter.