Jaden DLB1-0D40S2G, Instruction Manual

Page: 107 / 173

-107-
PA.24
Maximum deviation between
two PID outputs in reverse
direction
0.00%~100.00%
1.00%
☆
PA.23 and PA.24 respectively correspond to the maximum absolute value of the output
deviation in forward direction and in reverse direction.
PA.25
PID integral property
One’s
place
Integral separated
00
☆
Invalid
0
Valid
1
Ten’s
place
Whether to stop integral operation
when the output reaches the limit
Continue integral 0
Stop integral 1
•
Integral separated
If it is set to valid, , the PID integral operation stops when the DI allocated with function 38 "PID
integral pause" is ON In this case, only proportional and differential operations take effect.
If it is set to invalid, integral separated remains invalid no matter whether the DI allocated with
function 38 "PID integral pause" is ON or not.
•
Whether to stop integral operation when the output reaches the limit
If "Stop integral operation" is selected, the PID integral operation stops, which may help to
reduce the PID overshoot
PA.26
Detection value of PID
feedback loss
Not judging feedback loss
0.0%
0.0
%
☆
0.1%~100.0% 0.1%
PA.27
Detection time of PID
feedback loss
0.0s~20.0s
0s
☆
These parameters are used to judge whether PID feedback is lost.
If the PID feedback is smaller than the value of PA.26 and the lasting time exceeds the value of
PA.27, the Inverter reports Err31 and acts according to the selected fault protection action.
PA.28
PID operation at stop
No PID operation at stop 0
0
☆
PID operation at stop 1
It is used to select whether to continue PID operation in the state of stop. Generally, the PID
operation stops when the Inverter stops.