Jacto Advance 2000 AM-18, Operator'S Manual, Page: 87 / 118

5-87
5
M
A
INTE
NAN
CE
ADVANCE 2000 Conventional PTO Shaft
ATTENTION!
This procedure must be carried out by an experienced person with the machine
empty and very well scotched on a leveled ground. Do not allow people or animals
near the machine during this procedure. Operate equipment only with PTO shaft
equipped with safety protection (plastic covers).
Lubrication
Lubricate the points as indicated on the fig-
ure to the side every 8 hours.
OBSERVATION:
All of the points as indicated on
the figure on the side must be
lubricated. Under no hypoth-
eses must these lubrication
points remain without lubrica-
tion. Every 30 - 50 hours remove
the covers, clean and wash the
parts, lubricate and reassemble
the power takeoff shaft.
ATTENTION!
The lubrication of the power take-
off shaft (mounted) must be done
with the constant speed universal
joint in alignment with the male
/ female pipes. If it is done in any
other manner it will cause lubri-
cation faults and consequently
damages to the component.
A
Correct position for lubrication