Motor Controller
- The motor controller is located near
the motor just below the top plate of the SolarBee. The
motor controller is sealed in line with the electrical cord
that runs to the brushless motor.
The motor controller on the SolarBee receives power
and signals from the digital controller located inside the
low profile stand. These signals are used to operate
the brushless motor at the commanded speed. The
motor controller also sends feedback signals back up
to the digital controller.
Due to the high frequency of communication between
the motor controller and brushless motor, the two
components need to be located close to one another.
This is the primary reason for having the motor
controller located directly on the SolarBee.
All electronic connections on the SolarBee equipment
should only be used for the inputs or outputs that
they are labeled and designed for. If any of the leads
going into the digital controller are disconnected, be
sure when re-connecting to place them in the proper
position, following the proper power up/power down
procedures.
Wiring -
All electric wiring includes corrosion-resistant,
industrial cords with molded, weather and watertight
connectors. The connectors are indexed to prevent
improper wiring. A general electrical schematic can
be found in the Maintenance and Field Adjustment
section.
Motor Control Cord
Durable Wiring And Connectors
© 2020 Ixom | www.medoraco.com | 866 - 437 - 8076 | [email protected]
Features
Features
SB500PWc
10230_20210303
O&M_SB500PWc_10316_20210309a - 16
