STEP 1:
Position the end of the hose so that the clamp is centered over the 6” Hose Intake Tube. Secure the
torque bar to the hose by tightening the hose clamp using a 5/16" nut driver.
(See Figure 10)
STEP 2:
Leave the Torque Bar in the folded position ready for entry through the hatch.
STEP 3:
Lower the folded Torque Bar Assembly and Hose through the hatch to the entrant. The entrant then
needs to expand Torque Bar into the fully opened position, and install an M8 x 45mm bolt and nylock
nut through the torque bar tab to secure the torque bar in the open position.
(See Figure 11)
MACHINE FULLY ASSEMBLED
Fig 10:
Hose Clamped to Torque Bar
Fig 11:
Torque Bar Fully Opened
(Hose End Not Shown)
M8 X 45MM
BOLT & NUT
© 2020 Ixom | www.medoraco.com | 866 - 437 - 8076 | [email protected]
Small Frame Assembly
SB500PWc
SB500PWc Assembly
Assembly Diagram
10315_20200220
O&M_SB500PWc_10316_20210309a - 7
