Distribution Dish Level Setting
The machine distributor dish depth in the water is a
key factor in maintaining the near-laminar flow of water
coming off the machine.
The distribution dish level setting is measured from
the top lip of the dish up to the water surface. For the
Small Frame machine, set the depth level according to
the following table:
Model
Depth - Inch
Depth - cm
500PWc
1 1/2 - 2
3.8 - 5.0
1250PWc
3/4 - 1
2.0 - 2.5
Distribution Dish Level Adjustment
TOOLS RECOMMENDED:
No tools are necessary.
The collapsible machine model was designed specially
for potable tanks and reservoirs where the hatch size
is too small for confined space entry. Therefore, the
float assembly were designed to set the machine in the
correct depth of water when the machine is deployed.
There are no adjustments that needed for setting the
dish depth. After the reservoir has been drained and
refilled, the machine will automatically redeploy itself. It
is a good idea to visually check the machine to confirm
that the machine had properly deployed itself
in the case of the tank being drained and refilled.
Refer to table
to the left.
Distance Between Distributor
Dish And Water Level
Dish
Level
Water
Level
Water Level Refer to table upper left.
Release
Channel
Refer to table
to the left.
Model may
vary
© 2020 Ixom | www.medoraco.com | 866 - 437 - 8076 | [email protected]
Maintenance
Small Frame Dish Levels
Series Small Frame Mixers
10414_20200220
O&M_SB500PWc_10316_20210309a - 24
