Impeller Assembly Removal
In the case that there is buildup below the impeller that
cannot be reached, the impeller assembly can easily be
removed.
TOOLS RECOMMENDED:
Elbow High Rubber Gloves
Garbage Bag
STEP 1:
With machine off locate the 3 fasteners on the
top plate that attach it to the frame and remove them.
STEP 2:
Firmly grasp the top plate and pull straight up on
the impeller assembly.
STEP 3:
Observe and clean any debris located on the
bottom of the impeller.
STEP 4: Observe and clean any debris located down
in the dish where the impeller rests. Place the debris
into a garbage bag and remove from pond to prevent it
from going through machine again.
Follow all local
laws and regulations when disposing of any
materials collected.
STEP 5:
Once clean, place impeller assembly back
in place. Be sure bottom of impeller shaft fits into the
bushing in the dish and that the 3 top plate holes are
aligned with the top of the frame.
STEP 6:
Replace the 3 fasteners that were removed
in Step 1.
STEP 7:
Turn machine back on.
1250PWc Impeller Assembly
500PWc Impeller Assembly
Turn Machine Off Before
Performing Maintenance
CAUTION: TURN MACHINE OFF BEFORE WORKING NEAR IMPELLER! WEAR PROTECTIVE
GLOVES AND BE CAUTIOUS OF SHARP LEADING EDGES ON IMPELLER BLADES WHILE
CLEANING! FAILURE TO FOLLOW THESE WARNINGS COULD LEAD TO INJURY!
Top Plate
Top Plate
© 2020 Ixom | www.medoraco.com | 866 - 437 - 8076 | [email protected]
Maintenance
SB / GF Small Frame Impeller Assembly Removal
SB / GF Series Small Frame Mixers
2089_10245_20200220
O&M_SB500PWc_10316_20210309a - 27
