STEP 1:
Locate one end of the hose section and place hose clamp over the end. Be sure that hose and
clamp are installed above the metal rib of the flange and then tighten hose clamp as tight as possible
to firmly secure hose.
(See Figure 6)
STEP 2:
Fasten Hose to bottom of machine by pushing hose up and all the way up above metal rib.
(See Figure 7)
STEP 3:
Locate end of the Hose Section opposite of the machine and insert the 6” Tube for 6” Hose Intake
inside the end of the hose until approximately flush as shown.
(See Figure 8)
STEP 4:
Insert a 6” Hose Clamp and insert the end through one of the two small flat slots with Hose Clamp on
top of the Torque Bar as shown. Either slot will work fine.
(See Figure 9)
Fig 8:
Inner Hose Tube for Intake
Fig 6:
Attaching Hose to Frame
Fig 9:
Torque Bar Closed with Hose Clamp
DISH AND FLOAT
ARM ASSEMBLY
HOSE
HOSE CLAMP
Fig 7:
Hose Attached to Frame
© 2020 Ixom | www.medoraco.com | 866 - 437 - 8076 | [email protected]
Small Frame Assembly
SB500PWc
SB500PWc Assembly
Assembly Diagram
10315_20200220
O&M_SB500PWc_10316_20210309a - 6
