Digital Controller
- The digital controller is located
inside the the low profile solar panel stand. The
digital controller operates and monitors the SolarBee.
The digital controller is programmed with application
specific run schedule, fallback rpm, and battery charge
settings. The SolarBee's Design and Application
Engineering groups are constantly reviewing the
program to optimize operation. The digital controller
can be updated with a new program (firmware) using
a SD (Secure Digital) Card, similar to that of a digital
camera's memory stick.
All solar energy collection and motor operation are
managed by the digital controller. This component
has two primary functions: (1) To direct and divide the
power being collected by the PV module(s) between
the brushless motor and battery. (2) To serve as the
main control center that operates the brushless motor.
There are 3 PV module connections located on the
front face of the digital controller. If the supplemental
AC power accessory was purchased, a connection will
be located on the right side face. The supplemental
power connection is used only in applications where
AC grid power is desired.
The left side face of the digital controller contains the
brushless motor connection, battery connection, and
On/Off switch. The On/Off switch activates power
to the motor. When the switch is turned to the Off
position, the motor will not operate. The charging
function of the controller will continue to charge the
battery even when the switch is turned off.
SCADA outputs offering machine operation parameters
reside within the digital controller. Please contact
SolarBee if you are interested in receiving these
parameters.
Front Face Of Digital Controller
Left Side Face Of Digital Controller
© 2020 Ixom | www.medoraco.com | 866 - 437 - 8076 | [email protected]
Features
Features
SB500PWc
10230_20210303
O&M_SB500PWc_10316_20210309a - 15
