Distributor Dish / Hose
The distributor dish, structural members, structural
fasteners, and mounting brackets are constructed of
stainless steel.
Distributor Dish
- Near-laminar flow is achieved by
the SolarBee due to its uniquely designed distributor
dish. The impeller rotates while sitting within the lower
half of the distributor dish. The gentle water movement
strengthens the induced flow effect (water movement
occuring between the lower water layer entering the
machine and the upper water layer leaving the dish).
The top lip of the distributor dish is set approximately
1-1/2 inch to 2-inch (3.8cm - 5.0 cm) below the
surface of the water to achieve best flow results. The
distributor dish depth is set at the factory and should
not need adjustment after deployment.
Hose
- The hose extends from below the dish down to
the floor of the reservoir. The intake level is generally
set just above the floor of the reservoir. As the water
level fluctuates, the hose remains at a fixed placement
on the reservoir floor by the use of a torque bar as the
extra hose lays on the bottom. The intake draws water
horizontally into the hose.
The contact between the torque bar and the floor
prevents the machine from rotating or moving out of
place. The machine naturally has a very small torque
due to impeller rotation.
Hose With Bend Keeping
Position Stationary
Distributor Dish
© 2020 Ixom | www.medoraco.com | 866 - 437 - 8076 | [email protected]
Features
Features
SB500PWc
10230_20210303
O&M_SB500PWc_10316_20210309a - 19
